Best atc climbing2/27/2024 The rope should be running parallel to the ATC cable. Clip the locking carabiner through both the bight of rope and cable.If you are using an ATC with a high friction side, make sure that the brake strand is on the side that you prefer (depending on your situation). Insert it into one of the rope slots in the ATC. Make sure all the buckles are doubled back (if required) and tightened. If you want to learn more about belaying a climber from above, check out these 3 methods here. Every climber will start off with learning top rope belaying.Īll the ATC variations mentioned above can be used for top rope belaying. This is the setup you will see in indoor climbing gyms. In top rope belaying, the climbing rope runs from the belayer’s belay device to the anchor point at the top of the climb and back down to the climber’s harness. This article will cover top rope belaying. The compatible rope sizes will be printed on the frame as well. Some ATCs can only be used with ropes of a certain range of diameters. It is no different from belaying with a regular ATC. You can use the ATC on the opposite direction, with the brake strand on the regular side. In some cases, if you are using a thicker rope, you may find the friction too high on the high friction side.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |